VINTAGETRACTORS.COM
AND
RUSTY ACRES RANCH
Wheel, Weights,
Front end, and steering Parts for IHC tractors
- 
Cub rear rim #2, 6 x 24, good condition, $80
Cub rear wheel center, very good condition, $40
Rear Rim to Rear center bolt and nut, $1 each
351371-R1 Cub front wheel weight, $75 each, three available,
can ship inexpensively in a flat rate box
2 1/2 x 12 inch wheel #2, pitting on inside of rim,
some rust through, usable if repaired, free with any order, you
just pay the shipping
- 
= 
Front end support, steering box, and radiator bottom
#3, tag #76318, radiator tank has freeze split repair as shown
-this tank has been water tested and does not leak, $90
Front end support, steering box, and radiator bottom
#1, no tag, radiator tank has freeze split repair as shown at
the yellow arrows-this tank has been water tested and does not
leak, $80
Front end support, steering box, and radiator bottom
#2 with tag # 56784, radiator tank has freeze split as shown at
the yellow arrows and will need repair, as-is, $45
- 
350889R1 Steering gear base , very good condition,
similar to above, $30
Steering shaft in the steering base, very good splines
and surfaces, $45
Cub steering gear $20
Axle center section, no cuts, not repairs, $50
Center section #2, some reinforcment, $10
Pivot pin for front axle,$10
Axle clamp, two available, $12 each
- 
-
Spindle to fit the knee shown below, $25
Good spindle complete with hub and hub cap, $50
Steering arms with incorrect jam nut, $25 RH only is
available
- 
LH Steering arm with correct jam nut, $30 each your
choice
Front axle pivot pin, $10
New tie rod clamping plate, $4 each
Used clamping plate, $2 each
Center steering arm, $12
Sets of two tie rods with center connector plate, $60
each set, your choice
Front wheel hub, $20 each
Front hubcaps, $10 each
Steering post, $25
Steering shaft support knuckle: $12
Retainer for steering shaft, $8
Steering shaft, $20
- 
Very nice steering wheel, $30, your choice
Nice Steering wheel, will need some filling on the
rubber, $15